What Plumber To Call If Your Home Has Low Water Pressure | Denton, TX
Photo By coffeekai at istock
You are rushing to the bathroom to take a quick shower in the morning frenzy to show up in an early office meeting. However, you enter the shower only to find that the water is pouring out in a sad, slow drizzle. Let’s face it; we are all too familiar with clogged drains and pipes that are bad enough to call in a plumber. But what to do when the issue is to do with the amount of water coming out?
The average in-home water pressure ranges from about 40 to 45 pounds per square inch (or PSI). If you feel like you’re dealing with slow water output in your shower, faucet, sink, or toilet, chances are your pressure has slipped below this number, and you are dealing with a low water pressure situation.
At times low water pressure in your home can be fixed easily, and sometimes, you may need to get a plumber to do it for you. Here’s what you can do if your home has low water pressure:
Open Your Main Shutoff Valve
The main shutoff valve acts as a gateway for water entry to your home from the city supply. If you have recently undertaken any plumbing work, probably the main shutoff valve was adjusted and not restored. If the valve is not open completely, it can limit incoming water flow and result in low water pressure.
Reach out to your valve located either in your basement or on the outside wall of a utility area in your home facing the street and turn it on or adjust it to its optimal level. If you are unsure where the valve is located or how to handle it, contact a professional to guide you.
Check the Water Meter Valve
Unlike the main shutoff valve, the water meter valve is regulated by your local water department, and it’s not recommended to tamper with it unless there is an emergency. However, it doesn’t hurt to check if it’s all the way open. This valve is located right by your water meter and controlled by the handle that should lie parallel to your supply line or water pipe. If it’s altered, contact your local water department and they will suggest the right steps to ease your low water pressure concerns. Else, you can also contact a certified plumber who can advise on the next steps.
Hot Water Heater Problems
Believe it or not, your hot water heater may be the culprit, as it can affect the pressure of both hot and cold water in your home. Due to the gradual hard water build-up over time, minerals and other sediments can accumulate within your heater and block the flow of water going in and out. It’s recommended to get your hot water heaters periodically checked by an efficient plumber.
Aerator Screen Might be Clogged
Having a slow faucet problem? The chances are greater that the aerator screen is clogged. But what is an aerator screen anyway? This is the mesh screen located at the end of your faucet, and its tiny holes control water flow for a steady stream of water outflow. If you have a low water pressure issue only with that particular faucet, it can be due to a clogged aerator screen. You can try removing it and soaking it in hot water or replacing it with the help of a professional.
Clogged or Corroded Pipes
Low water pressure may also be as a result of a bigger problem of clogged or corroded water pipes in your plumbing system. A clog can prohibit water from flowing and keep the water concentrated in one part of the pipeline. Depending on the size of the clog, the flow of water can be slow, and if not cleared on time, it can result in burst pipes.
On the other hand, corroded water pipes occur due to the degradation or rusting of pipes associated with aging. If your home at Denton, TX is older, you could be facing corrosion issues. Especially if low water pressure is accompanied along with a weird taste or discoloration, you may be dealing with a bigger problem on hand.
If you suspect clog or corrosion, contact a reputed plumber for a thorough inspection and assessment of your plumbing system.
Water Pressure Regulator Issues
Most homes may have a water pressure regulator that monitors the water flow. If the regulator is malfunctioning, your water pressure can go low or high. If you happen to notice a sudden low water pressure across all pipes in your home, the water pressure regulator may be to blame. Replacing the regulator is best left to the trusted hands of a skilled plumber. Contact a local professional if you notice low water pressure throughout your home.
Leaks in Pipes
Check for water leaks, water stains, and moisture accumulation around appliances like dishwashers or washing machines, sinks, toilets, showers, bathtubs, underneath cabinets and behind countertops. This can indicate a leakage issue in your plumbing system.
A leak anywhere within your plumbing can undermine the flow of water and create low water pressure. So keep an eye out for water stains in your ceilings and walls and take appropriate action to hire a local plumber to address the leakage issue.
Contact the Experts at Denton, TX for your Low Water Pressure Issues
Trust the experienced plumbers of bluefrog Plumbing + Drain of North Dallas to fix your low water pressure issues. We ensure to provide you the best remediation and replacement plumbing services after a complete inspection of your problem. Our exclusive right solution guarantee is a testament to the work we do. We care about 100% customer satisfaction and don’t settle for less. Contact us at 469-214-2582 and our plumber will be available to help you anytime.
Priority Service