Top Reasons for Pipe Breaks and Why It Is Important to Call a Plumber Immediately | Irving, TX
Whether you’re a homeowner or a commercial business owner, you may agree that broken pipes are such a headache. Broken pipes inside or outside of your place can interrupt your business operations. Water can inundate your home or business; and inflict severe damage to your valuables, assets, and structure.
Studies show that water loss potentially can be around 400 liters when pipes burst or break. And that is equivalent to having two full baths in an hour. In other words, if the problem is not addressed timely by calling a plumber for a repair job, you can have nearly 48 full water baths or about 9,600 liters of water on your premises in a day due to burst or broken water pipes.
Though there can be many reasons for broken and burst water pipes, here are some of the top ones:
Reason #1— Freezing Temperatures
Freezing temperature is perhaps the most common and top reasons for broken pipes. Water supply pipes tend to burst when they exposed to freezing temperatures. When they come into contact with air below 28° F, the pipes freeze and, eventually, rupture. Pipes located in areas such as attic or crawl spaces are at higher risk.
During the winter, ice can buildup in water plumbing pipes, and so does the pressure inside it. As the ice puts pressure on the pipes, and the pressure also increases, which will make the pipes burst. Often, pipes break from the weaker or middle joints, and as most piping in the home or commercial facilities is hidden in roof spaces or walls, bursting of the pipes can be devastating and cause severe structural damage. This is an emergency and requires a quick plumbing job. Therefore, you must get in touch with an experienced plumber immediately.
Reason #2— Water Pressure
Usually, the water supplied by the city through the waterline has high pressure. A pressure regulator is therefore used at the meter to lower the water pressure bringing it to a safe level of nearly 40 to about 50 psi. This helps ensures that household plumbing does not get damaged due to high pressure.
However, sometimes, the pressure regulator is either defective or is not installed/adjusted properly and thus fail to regulate the water pressure level correctly. Failure to control the water pressure may raise the pressure high enough, causing the water pipes to rupture and eventually, burst.
When this happens, it is advisable to call a plumber right away before severe damage is done. An experienced plumber is well-trained to handle such situations. They will quickly check the regulator and attach a gauge to it to check the pressure. If problems with the regulator are detected, they will replace it and repair the pipes, resolving the issue immediately.
Reason #3— Clogging
Another top reason for pipe bursts and breaks is clogging. Pipes can get clogged for several reasons like an accumulation of debris such as leaves or sediments inside them or tree roots penetrating the pipelines. You should clean the pipes and remove debris from them regularly so they can get clogged burst over time. If it seems like the water supply has slowed down in your pipes, this could be because of a clog that needs to be addressed. It is wise to call a plumber to inspect the pipes before they burst and break.
Reason #4—Corrosion
Galvanized, and copper pipes are both susceptible to weathering and corrosion. That is what causes the pipes to become damaged and fail. A major cause of corrosion is the PH factor of the water supplied by the local city. When the PH level of the water is below 7, it is considered as acidic, and this causes the pipes to corrode overtime on the inside and the outside. Another common sign that indicates corrosion in pipes is pinhole leaks. These types of leaks cause the water to leak out in small amounts. If you happen to spot such leaks in your water pipes, it’s best to get in touch with a plumber and get your pipes inspected right away. Ignoring this sign like this can lead to serious problems in the long run.
Signs of Damaged or Broken Water Pipes
Here are some signs that indicate that your water pipes are damaged or broken:
- Loss of water pressure
- Damp patches on the ceiling and walls
- Unusual noises from the water main
- Frequent electrical faults
If you spot any of these signs, be sure to call a plumber for an inspection right away.
Call Bluefrog Plumbing + Drain in the Irving, TX Area
When water pipes break, it can wreak havoc in your home or business. Delaying can cause severe damage to your premises and valuables. For immediate and emergency assistance, call Bluefrog Plumbing + Drain of North Dallas. They have a team of experienced plumbers in the Irving, TX area who can visit your home or business and repair broken pipes immediately. Bluefrog Plumbing + Drain extend plumbing services to both commercial and residential owners and is available around the clock.
Priority Service